Install OpenWrt Xiaomi Router (100MB)

Visit this link to get to the documentation for OpenWRT Xiaomi 100MB, and this link for going to the Repo Exploit OpenWRT

git clone [Repo Exploit OpenWRT](https://github.com/acecilia/OpenWRTInvasion)

IMPORTANT: Connect through Ethernet, as OpenWRT installation will disable WiFi per default

IMPORTANT: Make sure the snapshot used to update the firmware is image and not initramfs. You will be able to see that by getting into the Xiaomi

Setting up default configuration of router #

Make sure router is in default state (after configuring it initially). I followed this manual here https://manuals.plus/xiaomi/router-4a-gigabit-edition-manual. Make sure router is using default IP 192.168.31.1. I stetted up region as Spain because Senegal was not available, and you also need to accept Terms and Conditions (as always).

Setting up your environment #

To set up the environment be sure to be in the directory where you have cloned OpenWRT exploit, then proceed as follows:

cd OpenWRTInvasion/
virtualenv .venv
source .venv/bin/activate
pip install -r requirements.txt

Even though the default method of installation is the normal pip install command, I had to run the following due to connectivity issues:

pip3 install -r requirements.txt --default-timeout=100

Running the exploit and accessing the router #

When I ran the exploit, the prompts were different as per other users in Github. For example, I was not asked for the Stok value, but only the IP.

python3 remote_command_execution_vulnerability.py

Easiest way to get into the server will be:

telnet 192.168.31.1

Installing new firmware #

Download the firmware version for that Router model.

IMPORTANT: Make sure the snapshot used to update the firmware is image and not initramfs. You will be able to see that by getting into the Xiaomi

curl --insecure [link_to_snapshot] > /tmp/sysupgrade.bin

We used the following link (https://downloads.openwrt.org/snapshots/targets/ramips/mt76x8/openwrt-ramips-mt76x8-xiaomi_mi-router-4a-100m-intl-squashfs-sysupgrade.bin) and it worked. If it does not work for you, read the documentation to make sure you use the correct link. As said in the beginning, the image has to be a sys-upgrade image.

curl --insecure https://downloads.openwrt.org/snapshots/targets/ramips/mt76x8/openwrt-ramips-mt76x8-xiaomi_mi-router-4a-100m-intl-squashfs-sysupgrade.bin > /tmp/sysupgrade.bin

Install and reboot

mtd -r write /tmp/sysupgrade.bin OS1

Get through SSH to router and install LuCI #

ssh [email protected]

Install the required packages as a basic installation.

opkg update
opkg install luci
Now you can open LuCI interface.

Install the required packages for SSL encryption

opkg update
opkg install luci-ssl
/etc/init.d/uhttpd restart

Reload LuCI interface and verify that you are using HTTPS.